Treatment method after welding machine enters water
Summer is coming, and most areas of the country are about to enter the rainy season. Water ingress from the welding machine occasionally occurs. What should I do if the welding machine has water ingress?
The design of the upper cover, side cover and front and rear panels of general welding machines
Has a certain protection against rain,
It can prevent rainwater from entering the welding machine under light rain
The following measures should be taken for other causes of water ingress in the welder:
If water is found in the welding machine, immediately stop working, cut off the power, and remove the power cord from the power distribution cabinet to prevent electric shock.
Move the welding machine to a safe place to prevent water from entering it again.
Disassemble the casing, check the water intake, tilt the welder to drain the water, and then dry or dry it naturally, and blow off the dust with compressed air.
It is necessary to find a professional to check the internal parts of the welder and the circuit board for water stains and corrosion. If there is any damage, replace the damaged components and circuit board; check whether the wire is broken due to corrosion, and if there is any corrosion, rewire.
After careful inspection, there is no obvious damage, you can power on and test the machine.
If it still does not work, please contact professional maintenance personnel for repair.